As for the password, you should be able to check right through it without one but if you have two profiles already there's a 99.9% chance that one's set for manipulation, the other isn't. The names of profiles can be edited to whatever you want without changing any of their settings FYI. You should have more than one profile in there, what are the names of the profiles you have? There's usually at least two profiles, one for manipulation and one for default coding which is what you're looking for. Open FSW_PSW.MAN, select all, delete, save & exit., then run SG_CODIEREN to the 2URAD ECU? man file for the 2URAD to overcome this issue by doing this: Problem is when I try to edit the profile to uncheck manipulation it asks me for a password.Īny ideas on how I can run SG_CODIEREN to reset the 2URAD ECU? If manipulation is off, the software will use the VO and the daten files to generate the default file that would have been found in the module originally based on the vehicle options list, which I believe is what I need to do now. MAN file in the module when you do a SG_codieren job. I read that if you use a profile that has 'manipulation' enabled in the settings, the software will upload the content of the. Hi, I have successfully added $644 into VO in CAS and NFRM, but when I try SG_CODIEREN to reset the 2URAD ECU I get an error in German.

Just off the top of my head I know INPA was missing quite a few functions in the script selections (engine, trans, chassis, etc.) If that's all you're going to use it for then it should be fine.

Ncs expert edit profile password